Torque Specifications
WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Catalytic converter-to-exhaust pipe bolts | 40 | 30 | - |
| Cooler tube nut-to-case fitting | 18 | 13 | - |
| Digital transmission range (TR) sensor bolts | 9 | - | 80 |
| Electronic pressure control (EPC) solenoid bracket | 10 | - | 89 |
| Exhaust flange bolts | 40 | 30 | - |
| Exhaust flange nuts | 48 | 35 | - |
| Extension housing bolts | 28 | 21 | - |
| Extension housing stud | 28 | 21 | - |
| Front pump bolts | 27 | 20 | - |
| Front pump support bolts | 23 | 17 | - |
| Ground wire | 23 | 17 | - |
| Inspection cover bolts | 35 | 26 | - |
| Main control valve body boltsa | - | - | - |
| Main control valve body cover plate boltsa | - | - | - |
| Main control valve body reinforcement plate bolts | 10 | - | 89 |
| Manual control valve detent lever spring bolt | 10 | - | 89 |
| Manual lever shaft inner nut | 32 | 24 | - |
| Output shaft speed (OSS) sensor bolt | 12 | 9 | - |
| Parking brake cable bracket bolt | 55 | 41 | - |
| Pressure tap plugs | 12 | 9 | - |
| Rear driveshaft bolts | 103 | 76 | - |
| Rear insulator bolts | 90 | 66 | - |
| Rear transmission support crossmember bolts | 70 | 52 | - |
| Selector lever cable bracket | 14 | 10 | - |
| Separator plate bolt | 35 | 26 | - |
| Servo piston installer bolt | 5.6 | - | 50 |
| Starter B+ cable | 12 | 9 | - |
| Starter bolts | 25 | 18 | - |
| Starter solenoid nut (small) | 6 | - | 53 |
| TCC solenoid bolt | 10 | - | 89 |
| Torque converter nuts | 36 | 27 | - |
| Transmission case bolts | 48 | 35 | - |
| Transmission filler tube bolt | 48 | 35 | - |
| Transmission fluid cooler tube case fittings | 21 | 15 | - |
| Transmission fluid pan bolts | 14 | 10 | - |
| Transmission insulator nuts | 30 | 22 | - |
| Transmission selector lever cable | 30 | 22 | - |
| Turbine shaft speed (TSS) sensor bolt | 11 | 8 | - |
a Specific tightening sequence is required. See the appropriate procedure.