LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2549 (Automatic Transmission - Automatic Transaxle/Transmission - 4R70E/4R75E) >> In-Vehicle Servicing >> Electronic Pressure Control (EPC) Solenoid >> Removal

Electronic Pressure Control (EPC) Solenoid: Removal

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the manual control lever. For additional information, refer to Manual Control Lever Shaft and Seal .
    2. CAUTION: Do not pull on the molded lead frame. This may cause damage to the connector ends. Carefully pry up on the locking tabs to disconnect the solenoids. Disconnect the molded lead frame from the solenoids.
  2. Disconnect the molded lead frame from the solenoids.
    1. Disconnect the shift solenoid SSA and SSB.
    2. Disconnect the torque converter clutch (TCC).
    3. Disconnect the electronic pressure control (EPC) solenoid.
    4. Disconnect the bulkhead interconnector.
    3. Fig 1: Identifying Molded Lead Frame And Solenoids
    G04584282Courtesy of FORD MOTOR CO.
  3. Remove the EPC solenoid.
    1. Remove the bolt and EPC solenoid bracket.
    2. Remove the EPC solenoid.
    4. Fig 2: EPC Solenoid, Bracket & Bolt
    GF0014068Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals