LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2549 (Automatic Transmission - Automatic Transaxle/Transmission - 4R70E/4R75E) >> In-Vehicle Servicing >> Digital Transmission Range (TR) Sensor >> Installation

Digital Transmission Range (TR) Sensor: Installation

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the digital TR sensor and loosely install the bolts.
    2. Fig 1: Transmission Range (TR) Sensor Bolts
    GF0014072Courtesy of FORD MOTOR CO.
    NOTE: The manual control lever must be in the NEUTRAL position.
  2. Using the special tool, align the digital TR sensor slots. The tool is designed to fit snugly.
    3. Fig 2: Aligning Digital TR Sensor Slots Using Special Tool (307-351)
    G04584268Courtesy of FORD MOTOR CO.
    CAUTION: Tightening one screw before tightening the other may cause the sensor to bind or become damaged.
  3. Tighten the screws in an alternating sequence.
    • Tighten to 9 Nm (80 lb-in).
    4. Fig 3: Aligning Digital TR Sensor Slots With Special Tool
    G04584269Courtesy of FORD MOTOR CO.
  4. With the manual control lever in overdrive, connect the selector lever cable.
    • Tighten to 30 Nm (22 lb-ft).
    5. Fig 4: Selector Lever Cable At Transmission
    GF0014071Courtesy of FORD MOTOR CO.
  5. Connect the digital TR sensor electrical connector.
    6. Fig 5: Transmission Range (TR) Sensor Electrical Connector
    GF0014070Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals