Removal & Installation
WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
- Drain the cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding .
- Remove the bolt and position aside the power steering reservoir.
- To install, tighten to 10 Nm (89 lb-in).
- Disconnect the degas bottle overflow hose and supply hose.
- Remove the bolt and the degas bottle.
- To install, tighten to 10 Nm (89 lb-in).
- Disconnect the upper radiator hose and position aside.
- Detach the transmission cooler tubes from the cooling fan motor and shroud.
- Disconnect the cooling fan motor electrical connector.
- Remove the 2 bolts and the cooling fan motor and shroud assembly.
- To install, tighten to 7 Nm (62 lb-in).
- To install, reverse the removal procedure.
- Fill and bleed the cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding .
NOTE:
Position the lower radiator hose away from the cooling fan motor and shroud.