Wheel Studs: Installation
WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
- Install the wheel stud.
- Install 4 washers onto the wheel stud.
- Install the wheel nut. Tighten the wheel nut until the wheel stud seats fully onto the wheel hub flange.
- Remove the wheel nut and washers.
- Install the brake disc.
- Position the caliper and anchor plate assembly onto the steering knuckle and install the bolts.
- To install, tighten to 160 Nm (118 lb-ft).
- Install the wheel and tire. For additional information, refer to REMOVAL & INSTALLATION article.