LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2542 (Seat System - Seats) >> Diagnostic Tests >> Seats >> Pinpoint Tests >> Pinpoint Test S: The Heated Seat is Inoperative - Right Rear, Does Not Operate in High >> Normal Operation

Normal Operation

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.

The right rear heated seat module receives voltage feed on circuit 1445 (RD/LG), ignition voltage feed on circuit 1040 (RD/BK) and is supplied ground on circuit 57 (BK). When the heated seat control switch is pressed with the ignition switch in RUN or START, a ground signal is sent to the heated seat module on circuit 581 (RD) to command the system ON or OFF (HIGH heat mode).

This pinpoint test is intended to diagnose the following:

scientia non olet · About LEMON Manuals