Heated Seats (Front)

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If a passenger seat cushion heater mat is inoperative, a new OCS system service kit must be installed and a new cushion heater mat must be installed to the OCS system service kit foam pad.

NOTE: When installing an OCS system service kit equipped with heated seats, a new seat cushion heater mat must be installed. Do not reuse the OEM OCS cushion heater mat. The OCS system service kit does not come with a cushion heater mat.

NOTE: When installing a new driver seat heater mat (cushion or backrest) or passenger seat backrest heater mat, a new foam pad with the heater mat already attached is required. A new seat heater mat by itself is not available for service for the driver seat.

Each heated seat is controlled by a switch on the door trim panel.

The heated seat system:

will have one heated seat module attached to the inside of the passenger front door trim panel.
will only operate with the ignition switch in RUN.
will operate with battery voltage as low as 9 volts.
will maintain a temperature automatically once it is selected.
will heat to the selected temperature each time the ignition switch is turned to RUN if the heated seat is not switched OFF.