LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2517 (Driveline System - General Information) >> General Procedures >> Driveshaft Runout and Balancing >> Driveshaft Inspection

Driveshaft Inspection

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Driveline vibration exhibits a higher frequency and lower amplitude than high-speed shake. Driveline vibration is directly related to the speed of the vehicle and is noticed at various speeds. Driveline vibration can be perceived as a tremor in the floorpan or heard as a rumble, hum or boom.
NOTE: Refer to SPECIFICATIONS  for all runout specifications.
    NOTE: Do not make any adjustments before carrying out a road test. Do not change the tire pressure or the vehicle load.
  1. Carry out a visual inspection of the vehicle. Operate the vehicle and verify the condition by reproducing it during the road test.
    • The concern should be directly related to vehicle road speed, not affected by acceleration or deceleration or could not be reduced by coasting in NEUTRAL.
  2. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
    • The driveshaft should be kept at an angle equal to or close to the curb-weighted position. Use a twin-post hoist or a frame hoist with jackstands.
  3. Inspect the driveshaft for damage, undercoating or incorrectly seated U-joints. Rotate the driveshaft slowly by hand and feel for binding or end play in the U-joint trunnions. Remove the driveshaft. For additional information, refer to DRIVESHAFT article. Inspect the slip yoke splines for any galling, dirt, rust or incorrect lubrication. Clean the driveshaft or install new U-joints as necessary. Install a new driveshaft if damaged. After any corrections or new components are installed, recheck for the vibration at the road test speed.
    • If the vibration is gone, test drive the vehicle.
    • If the vibration persists or the driveshaft passes visual inspection, measure the driveshaft runout.
scientia non olet · About LEMON Manuals