LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 251 (Front Suspension) >> Removal & Installation >> Spindle >> Installation

Removal & Installation: Spindle: Installation

WARNING: This page is about a different car, the 2002 Ford RV Cutaway, 2002 Ford Econoline, 2002 Ford E450 Super Duty, and 2002 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure ball joint seals are in position. Place spindle and ball joints into axle. Install lower ball joint nut and tighten to specification. See TORQUE SPECIFICATIONS  .
  2. Install camber adjuster over upper ball joint stud. Ensure camber adjuster is properly aligned. If camber adjustment is required, special camber adjusters must be installed. Tap camber adjuster into spindle. Tighten upper ball joint nut to specification.
  3. Install cotter pin. Install axle clamp bolt and tighten to specification. To complete installation, reverse removal procedure. Adjust wheel bearings. See WHEEL BEARING ADJUSTMENT  under ADJUSTMENTS & INSPECTION. Check and adjust front end alignment. See SUSPENSION SYSTEM-GENERAL INFORMATION article.
scientia non olet · About LEMON Manuals