LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 251 (Front Suspension) >> Removal & Installation >> Axle ("I" Beams) >> Installation

Axle ("I" Beams): Installation

WARNING: This page is about a different car, the 2002 Ford RV Cutaway, 2002 Ford Econoline, 2002 Ford E450 Super Duty, and 2002 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Do not tighten axle pivot bolts until vehicle is lowered, with the vehicle weight on the suspension.

To install, reverse the removal procedure. Tighten all nuts and bolts to specification. See TORQUE SPECIFICATIONS  . Check and align front end if necessary. See SUSPENSION SYSTEM-GENERAL INFORMATION article.

Fig 1: Exploded View Of Axle-To-Radius Arm Bolt
G00352427Courtesy of FORD MOTOR CO.
Fig 2: Exploded View Of Radius Arm Bracket Assembly
G00352428Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals