Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

Remove the lower A-pillar trim panel. For additional information, refer to A-PILLAR TRIM PANEL .
Disconnect the front door electrical connector at the A-pillar.

Fig 1: Locating Front Door Electrical Connector At A-Pillar
Courtesy of FORD MOTOR CO.
Remove the door check bolt.

Fig 2: Locating Door Check Bolt
Courtesy of FORD MOTOR CO.

NOTE: To minimize the possibility of cross threading, hand-start all fasteners during the installation.

NOTE: To avoid damaging the door, this step requires an assistant.

With a wax pencil, mark the position of each hinge and remove the hinge-to-door bolts.
- To install, tighten to 24 Nm (18 lb-ft).
  
  Fig 3: Locating Hinge-To-Door Bolts With Torque Specifications
  Courtesy of FORD MOTOR CO.
Remove the front door.
To install, reverse the removal procedure.
- Upon installation, verify that door is aligned. For additional information, refer to REMOVAL AND INSTALLATION .