Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Module configuration is only required if a new Parking Aid Module (PAM) is being installed.

Upload the PAM configuration information to the scan tool. For additional information, refer to PROGRAMMABLE MODULE INSTALLATION (PMI) .
Remove the RH rear quarter trim panel. For additional information, refer to QUARTER TRIM PANEL .
If replacing the parking aid speaker only, proceed as follows:
- Disconnect the electrical connector.
- Disengage the clips.
- Remove the parking aid speaker.
If replacing the PAM , proceed as follows:
- Disconnect the electrical connector.
- Remove the 2 screws.
- Remove the PAM .
To install, reverse the removal procedure.
- Download the configuration information to the PAM . For additional information, refer to PMI in ACCESSORY PROTOCOL INTERFACE MODULE (APIM) PROGRAMMING .