LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2489 (Bumper System) >> Removal And Installation >> Bumper - Rear, Without Trailer Hitch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear bumper cover. For additional information, refer to BUMPER COVER - REAR .
  2. Remove the 4 rear bumper nuts.
    • To install, tighten to 40 Nm (30 lb-ft).
  3. Remove the rear bumper.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals