LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2489 (Bumper System) >> Removal And Installation >> Bumper - Rear, With Trailer Hitch

Bumper - Rear, With Trailer Hitch

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear bumper cover. For additional information, refer to BUMPER COVER - REAR .
  2. Remove the 2 trailer hitch-to-back panel bolts.
    • To install, tighten to 40 Nm (30 lb-ft).
  3. Remove the 2 trailer hitch-to-back panel nuts.
    • To install, tighten to 40 Nm (30 lb-ft).
  4. Remove the 4 trailer hitch-to-body bolts.
    • To install, tighten to 175 Nm (129 lb-ft).
  5. Remove the trailer hitch.
    • Disconnect the electrical connector from the trailer hitch.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals