LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2484 (Fuel Charging System & Fuel Control System - 3.0L (4V)) >> Removal And Installation >> Throttle Body >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the Air Cleaner (ACL) outlet pipe. For additional information, refer to AIR CLEANER OUTLET PIPE .
  2. Disconnect the electronic throttle control electrical connector.
  3. Remove the 4 bolts and the Throttle Body (TB).
    • Discard the TB  gasket.
    • To install, tighten to 10 Nm (89 lb-in).
  4. To install, reverse the removal procedure.
    • Install a new TB  gasket.
scientia non olet · About LEMON Manuals