LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 248 (Front Suspension - 2WD - Excursion, F-250 & F-350 Super Duty) >> Removal & Installation >> Front Axle >> Removal

Front Axle: Removal

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Ford Pickup, 2004 Ford Excursion, 2003 Ford Pickup, 2003 Ford Excursion, and 2002 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support vehicle. Remove wheel and tire assembly. Remove front spindle. See SPINDLE . Support front axle with a jack. Remove coil spring. See COIL SPRING . Remove lower spring insulator and seat. Remove radius arm-to-axle bolt. See Fig 1. Remove radius arm-to-frame bracket pivot bolt. Remove radius arm.
  2. To remove right axle pivot bolt, relieve weight from suspension. On both sides, remove pivot bolt and axle. Check pivot bushings for wear or damage. Replace if necessary.
Fig 1: Removing Radius Arm -To-Axle Bolt
G00324335Courtesy of FORD MOTOR CO.