Ball Joints: Removal

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Ford Pickup, 2004 Ford Excursion, 2003 Ford Pickup, 2003 Ford Excursion, and 2002 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

Remove the wheel spindle or wheel knuckle assembly. For additional information, refer to SPINDLE .
Remove the lower ball joint grease plug.

Fig 1: Locating Ball Joint Grease Plug
Courtesy of FORD MOTOR CO.
Position the wheel spindle in a vise and remove the snap ring from the lower ball joint.

CAUTION: To avoid damage to the components, do not use heat to aid ball joint removal.

Fig 2: Locating Ball Joint Special Tool On Lower Ball Joint

Courtesy of FORD MOTOR CO.

Using the C-Frame and Screw Installer/Remover and Ball Joint Installer/Remover, remove the lower ball joint
Using the C-Frame and Screw Installer/Remover and Ball Joint Installer/Remover, remove the upper ball joint.

Fig 3: Locating Ball Joint Special Tool On Upper Ball Joint
Courtesy of FORD MOTOR CO.