LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2477 (Engine Cooling System - (Except Hybrid)) >> Removal And Installation >> Coolant Pump - 3.0L (4V) >> Installation

Coolant Pump - 3.0L (4V): Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using a new gasket, install the coolant pump and the 3 bolts.
    • Tighten to 10 Nm (89 lb-in).
  2. Install the coolant pump belt. For additional information, refer to COOLANT PUMP BELT .
  3. Connect the lower radiator hose to the thermostat housing.
  4. Install the ACL  outlet pipe. For additional information, refer to AIR CLEANER OUTLET PIPE .
  5. Fill and bleed the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
scientia non olet · About LEMON Manuals