LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2471 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Liftgate Latch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the liftgate trim panel. For additional information, refer to LIFTGATE TRIM PANEL .
  2. Disconnect the liftgate latch electrical connectors.
  3. Remove and discard the 3 liftgate latch bolts.
    • To install, tighten to 12 Nm (106 lb-in).
      Fig 1: Locating Liftgate Latch Bolts
      G06099889Courtesy of FORD MOTOR CO.
  4. Remove the liftgate latch.
    Fig 2: Locating Liftgate Latch
    G06099890Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals