LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2469 (Engine Controls - Electronic Engine Controls - 3.0L (4V)) >> Removal And Installation >> Crankshaft Position (CKP) Sensor >> Installation

Crankshaft Position (CKP) Sensor: Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the O-ring seal and install new as necessary.
    2. NOTE: Lubricate the CKP  sensor O-ring seal with clean engine oil.
  2. Install the CKP  sensor and bolt.
    • Tighten to 10 Nm (89 lb-in).
  3. Connect the CKP  sensor electrical connector.
  4. Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.
scientia non olet · About LEMON Manuals