LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2468 (Engine Controls - Electronic Engine Controls - 2.5L (Except Hybrid)) >> Removal And Installation >> Mass Air Flow (MAF) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the Mass Air Flow (MAF) sensor electrical connector.
  2. Remove the 2 screws and the MAF  sensor.
    • To install, tighten to 10 Nm (89 lb-in).
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals