LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2462 (Parking Aid System - Active Park Assist) >> Removal And Installation >> Active Park Assist Sensor >> Removal

Active Park Assist Sensor: Removal

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the fender splash shield screws and lower bolts. For additional information, refer to FENDER SPLASH SHIELD .
  2. Position the fender splash shield aside and disconnect the electrical connector.
  3. With a suitable tool (such as a flat-blade screwdriver) gently pry the retaining tabs to remove the active park assist sensor(s).
    • Remove the active park assist sensor(s) from the front bumper cover.
  4. To install, reverse the removal procedure.
  5. After installing the sensor(s), use the scan tool to verify that the active park assist sensor PIDs responding correctly. Carry out the AZIMUTH SYSTEM CHECK . If the active park assist sensor does not respond correctly, refer to ACTIVE PARK ASSIST .
scientia non olet · About LEMON Manuals