Occupant Classification System Module (OCSM) DTC Chart
WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
ITEM DESCRIPTION
| DTC(1) | Description | Action To Take | ||
|---|---|---|---|---|
| B1231 | Event Threshold Exceeded (Crash Data Memory Full) | INSPECT the passenger seat for damage. REFER to INSPECTION AND REPAIR AFTER A SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPLOYMENT . | ||
| B1317 | Battery Voltage High | GO to PINPOINT TEST Y . | ||
| B1318 | Battery Voltage Low | GO to PINPOINT TEST Y . | ||
| B1342 | ECU is Faulted | INSTALL an Occupant Classification Sensor (OCS) service kit. REFER to OCCUPANT CLASSIFICATION SENSOR - SERVICE KIT . | ||
| B2290 | Occupant Classification System Fault | GO to PINPOINT TEST AC . | ||
| B2909 | Belt Tension Sensor Fault | GO to PINPOINT TEST AD . | ||
| C1941 | Zero Seat Weight Test Failure | Can only be reported when carrying out System Reset. GO to PINPOINT TEST AC . | ||
| U0151 | Lost Communication with Restraints Control Module (RCM) |
NOTE:
The DTC will set in a module that is reporting a communication fault from another module on the data bus. The module that reports the fault is not the problem module. Do not install a new OCSM
as part of repair. REFER to
MODULE COMMUNICATIONS NETWORK
to diagnose the RCM
. RCM
does not respond to the scan tool. |
||
| U2050 | No Application Present | INSTALL a new OCS system service kit. REFER to OCCUPANT CLASSIFICATION SENSOR - SERVICE KIT . | ||
| U2051 | One or More Calibration Files Missing/Corrupt | INSTALL a new OCS system service kit. REFER to OCCUPANT CLASSIFICATION SENSOR - SERVICE KIT . | ||
|
||||