Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

Remove the rear seat cushion.
- Position the seat cushion forward.
- Release the locking tab and slide the rear seat cushion outward.
  
  Fig 1: Locating Rear Seat Cushion Locking Tab
  Courtesy of FORD MOTOR CO.
Unzip the cushion cover zipper.

Fig 2: Unzipping Cushion Cover Zipper
Courtesy of FORD MOTOR CO.

NOTE: Use care when separating the seat cushion trim cover from the hook-and-loop strips or the hook-and-loop strips may be torn from the seat cushion foam pad.

Invert and remove the cushion cover.

NOTE: Make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.

To install, reverse the removal procedure.