LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2452 (Seat System - Seats) >> Removal And Installation >> Seat - Front >> Installation

Seat - Front: Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The seat fasteners must be tightened in the sequence described in this procedure.
NOTE: The front passenger seat uses different mounting bolts than the driver seat. Make sure the correct bolts are used when mounting the front passenger seat.
    NOTE: Before installation, make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.
  1. Position the seat in the vehicle and connect the seat harness electrical connector(s).
    • Attach the wiring harness to the seat track.
  2. Install the inboard rear mounting nut and cover.
    • Tighten to 40 Nm (30 lb-ft).
  3. Install the outboard rear mounting nut and cover.
    • Tighten to 40 Nm (30 lb-ft).
  4. Repower the SRS  . For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion of SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING .
  5. Position the seat rearward and install the inboard front mounting bolt.
    • Tighten to 40 Nm (30 lb-ft).
  6. Install the outboard front mounting bolt.
    • Tighten to 40 Nm (30 lb-ft).
scientia non olet · About LEMON Manuals