Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For component identification and locations, refer to SEAT - EXPLODED VIEW, FRONT .

Remove the backrest cover. For additional information, refer to SEAT BACKREST COVER - FRONT .
Remove the backrest foam pad.
Remove the 2 screws and position aside the lumbar adjuster.
Detach the lumbar assembly from the backrest frame wires and remove.
To install, reverse the removal procedure.