LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2452 (Seat System - Seats) >> Disassembly And Assembly >> Seat Cushion - Driver >> Disassembly

Seat Cushion - Driver: Disassembly

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the seat backrest. For additional information, refer to SEAT BACKREST - FRONT .
  2. Remove the safety belt buckle pretensioner.
    • Disconnect and detach the safety belt buckle pretensioner and buckle switch electrical connectors from the seat track.
    • Detach the wiring harness pin-type retainer.
    • Route the wiring harness from between the seat track and cushion frame.
  3. Disconnect the electrical connector(s).
    • Disconnect the seat position sensor electrical connector and detach the wiring harness.
    • If equipped, disconnect the power seat track electrical connector and detach the wiring harness.
    • Detach the seat harness electrical connector from the seat track.
  4. Remove the 4 bolts and seat track.
    • To install, tighten to 25 Nm (18 lb-ft).
  5. If equipped, disconnect the cushion heater mat electrical connector.
    6. NOTE: Use care when separating the seat cushion trim cover from the hook-and-loop strips or the hook-and-loop strips may be torn from the seat cushion foam pad.
  6. Release the all the retainers and remove the cushion cover.
  7. Remove the cushion foam pad.
    • If equipped, note heater mat wire harness routing for correct installation.
  8. If equipped, release the locking tab and remove the heated seat relay from the bracket on the cushion frame.
    • Disconnect the relay electrical connector.
  9. To assemble, reverse the disassembly procedure.
scientia non olet · About LEMON Manuals