LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2442 (Power Transfer Unit (PTU)) >> In-Vehicle Repair >> Output Shaft Seal >> Installation

Output Shaft Seal: Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using the PTO Drive Gear Outer Oil Seal Installer, install the PTU  output shaft oil seal.
    Fig 1: Identifying PTO Drive Gear Outer Oil Seal Installer
    G06098384Courtesy of FORD MOTOR CO.
  2. Install the deflector.
  3. Install the PTU  output shaft flange. For additional information, refer to OUTPUT FLANGE .
scientia non olet · About LEMON Manuals