LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2441 (Information Center - Instrumentation, Message Center And Warning Chimes) >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test BC: DTC U0151 >> Pinpoint Test BC: DTC U0151

Pinpoint Test BC: DTC U0151

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. BC1 VERIFY THE CUSTOMER CONCERN 
    • Ignition ON.
    • Verify that there is an observable symptom present.
    • Is an observable symptom present? 
    • Yes:  GO to BC2  .
    • No:  The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
  2. BC2 CHECK THE COMMUNICATION NETWORK 
    • Ignition ON.
    • Enter the following diagnostic mode on the scan tool: Network Test.
    • Carry out the network test.
    • Does the RCM pass the network test? 
  3. BC3 RETRIEVE THE RECORDED DTCs FROM THE IC SELF-TEST 
    • Check for recorded IC  DTCs from the self-test.
    • Is DTC B1317 or DTC B1318 recorded? 
  4. BC4 RECHECK THE IC DTCs 
    • Clear the DTCs. Repeat the IC  self-test.
    • Is DTC U0151 still present? 
    • Yes:  GO to BC5  .
    • No:  The system is operating correctly at this time. The DTC may have been set due to high network traffic.
  5. BC5 CHECK FOR DTC U0151 SET IN OTHER MODULES 
    • Clear all DTCs.
    • Ignition OFF.
    • Ignition ON.
    • Wait 10 seconds.
    • Enter the following diagnostic mode on the scan tool: Self-Test.
    • Retrieve the continuous memory DTCs from all modules.
    • Is DTC U0151 set in the Occupant Classification System Module (OCSM)? 
scientia non olet · About LEMON Manuals