LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2441 (Information Center - Instrumentation, Message Center And Warning Chimes) >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test AR: DTC B1317 >> Pinpoint Test Ar: DTC B1317

Pinpoint Test Ar: DTC B1317

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the connector.
NOTE: DTC B1317 may be stored in the module memory due to past battery charging or vehicle jump starting events.
  1. AR1 CHECK FOR DTC B1317, B1676 OR P0563 SET IN OTHER MODULES 
    • Ignition ON.
    • Enter the following diagnostic mode on the scan tool: Self-Test.
    • Retrieve the continuous memory DTCs from all modules.
    • Is DTC B1317, B1676 or P0563 (PCM) set in more than one module? 
    • Yes:  REFER to CHARGING SYSTEM to diagnose an overcharging condition.
    • No:  GO to AR2  .
  2. AR2 CHECK THE BATTERY VOLTAGE 
    • Turn off all interior/exterior lights and accessories.
    • Start and run the engine at approximately 2,000 RPM for 3 minutes while monitoring the battery voltage.
    • Does the battery voltage rise to 15.5 volts or higher? 
    • Yes:  REFER to CHARGING SYSTEM to diagnose an overcharging condition.
    • No:  GO to AR3  .
  3. AR3 RECHECK FOR DTC B1317 
    • Turn the engine off.
    • Ignition ON.
    • Enter the following diagnostic mode on the scan tool: IC  Self-Test.
    • Clear the continuous memory DTCs.
    • Carry out the IC  self-test.
    • Is DTC B1317 present? 
    • Yes:  INSTALL a new IC  . REFER to INSTRUMENT CLUSTER (IC) . TEST the system for normal operation.
    • No:  The system is operating normally at this time. The DTC may have been set previously during battery charging or while jump starting the vehicle.
scientia non olet · About LEMON Manuals