LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2440 (Steering Column Switches) >> Removal And Installation >> Steering Column Multifunction Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering column opening trim.
  2. Remove the 3 lower steering column shroud screws.
  3. Remove the upper and lower steering column shrouds.
  4. Remove the 2 multifunction switch screws.
  5. Disconnect the multifunction switch electrical connector and remove the switch.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals