Removal and Installation
WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the rear wheel cylinder. For additional information, refer to WHEEL CYLINDER .
- Remove the brake flexible hose bracket bolt.
- To install, tighten to 15 Nm (133 lb-in).
- Compress the parking brake cable conduit locking tabs and pull the parking brake cable assembly through the backing plate.
- Remove the rear wheel hub. For additional information, refer to REMOVAL AND INSTALLATION .
- Remove the 4 backing plate bolts and the backing plate.
- To install, tighten to 85 Nm (63 lb-ft).
- To install, reverse the removal procedure.