Removal and Installation
WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Remove the exhaust intermediate pipe. For additional information, refer to EXHAUST INTERMEDIATE PIPE - 2.5L, HYBRID .
- Remove the 2 exhaust bracket bolts.
- To install, tighten to 25 Nm (18 lb-ft).
- Remove the 2 exhaust downpipe-to-exhaust manifold nuts and the exhaust downpipe.
- To install, tighten to 40 Nm (30 lb-ft).
- To install, reverse the removal procedure.
- Install new gaskets and nuts.