LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2422 (Exhaust System) >> Removal And Installation >> Catalytic Converter - 3.0L RH >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the exhaust Y-pipe. For additional information, refer to EXHAUST Y-PIPE - 3.0L .
  2. Disconnect the RH Catalyst Monitor Sensor (CMS) electrical connector.
  3. Remove and discard the 3 RH catalytic converter nuts and remove the converter.
    • Discard the RH catalytic converter manifold gasket.
    • To install, tighten to 40 Nm (30 lb-ft).
  4. To install, reverse the removal procedure.
    • Install a new gasket and nuts.
scientia non olet · About LEMON Manuals