LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2421 (Engine System - General Information) >> General Procedures >> Cylinder Bore Out-of-Round

Cylinder Bore Out-of-Round

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to appropriate article in Engine for the specification.
  1. Measure the cylinder bore in 2 directions. The difference is the out-of-round.
    Fig 1: Measuring Cylinder Bore Out-Of-Round
    G06073203Courtesy of FORD MOTOR CO.