LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2414 (Automatic Transmission - Electronically Controlled Continuously Variable Transmission (ECVT) - (Hybrid)) >> In-Vehicle Repair >> Differential Seals - LH >> Removal

Differential Seals - LH: Removal

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Turn the ignition to the OFF position.
  3. Remove the retainers and remove the LH splash shield.
    Fig 1: Locating LH Splash Shield And Splash Shield Retainers
    G06097824Courtesy of FORD MOTOR CO.
  4. Remove the drain plug and drain the transmission fluid.
    Fig 2: Locating Drain Plug
    G06097832Courtesy of FORD MOTOR CO.
  5. Remove the LH halfshaft. For additional information, refer to REMOVAL AND INSTALLATION .
  6. Using the Slide Hammer and Input Shaft Oil Seal Remover, remove and discard the LH differential seal.
    Fig 3: Identifying Slide Hammer And Input Shaft Oil Seal Remover
    G06393552Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals