LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2413 (Automatic Transmission - 6F35) >> In-Vehicle Repair >> Turbine Shaft Speed (TSS) Sensor >> Removal

Turbine Shaft Speed (TSS) Sensor: Removal

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING -- ESCAPE, ESCAPE HYBRID, MARINER & MARINER HYBRID .
  2. Remove the retainers and the LH splash shield.
    Fig 1: Locating LH Splash Shield Retainers
    G06376900Courtesy of FORD MOTOR CO.
  3. Disconnect the Turbine Shaft Speed (TSS) electrical connector, remove the bolt and the TSS  sensor.
    Fig 2: Locating Turbine Shaft Speed (TSS) Electrical Connector And Bolt
    G06376901Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals