LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2413 (Automatic Transmission - 6F35) >> In-Vehicle Repair >> Halfshaft Seal - RH, All Wheel Drive (AWD) >> Installation

Halfshaft Seal - RH, All Wheel Drive (AWD): Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a new halfshaft seal on the RH Halfshaft Fluid Seal Installer.
    Fig 1: Locating Halfshaft Seal On RH Halfshaft Fluid Seal Installer (307-428)
    G06376908Courtesy of FORD MOTOR CO.
  2. Using the RH Halfshaft Fluid Seal Installer, install the RH halfshaft seal.
    Fig 2: Identifying RH Halfshaft Fluid Seal Installer (307-428) On RH Halfshaft Seal
    G06376909Courtesy of FORD MOTOR CO.
  3. Install the PTU  . For additional information, refer to TRANSFER CASE-POWER TRANSFER UNIT (PTU) .
  4. Fill with clean transmission fluid to the correct level.
scientia non olet · About LEMON Manuals