LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2413 (Automatic Transmission - 6F35) >> Disassembly And Assembly Of Subassemblies >> Clutch Support Tower >> Disassembly

Clutch Support Tower: Disassembly

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using a suitable tool, remove and discard the 4 Teflon® seals.
    Fig 1: Removing Teflon Seals
    G06377157Courtesy of FORD MOTOR CO.
  2. Clean and inspect the clutch support tower for damage. Install a new clutch support tower if damaged.
    Fig 2: Identifying Clutch Support Tower
    G06377158Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals