LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2410 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Repair >> Exhaust Manifold - RH >> Removal

Exhaust Manifold - RH: Removal

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING -- ESCAPE, ESCAPE HYBRID, MARINER & MARINER HYBRID .
  2. Remove the 3.0L RH catalytic converter. For additional information, refer to CATALYTIC CONVERTER -- 3.0L RH .
  3. Disconnect the Heated Oxygen Sensor (HO2S) electrical connector.
  4. Remove the 3 exhaust manifold heat shield bolts and the heat shield.
  5. Remove the EGR tube fitting nut from the exhaust manifold.
  6. Remove and discard the 6 exhaust manifold nuts.
  7. Remove the exhaust manifold and discard the exhaust manifold gasket.
  8. Remove and discard the 6 exhaust manifold studs.
  9. Clean and inspect the exhaust manifold. For additional information, refer to INSPECTION AND VERIFICATION .
scientia non olet · About LEMON Manuals