LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2409 (Engine Mechanical - 2.5L (Except Hybrid)) >> In-Vehicle Repair >> Valve Springs >> Installation

Valve Springs: Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Check the seating of the valve collet.
  1. Using the Valve Spring Compressors, install the valve spring.
    • Insert the valve spring and the valve spring retainer.
    • Compress the valve spring and install the valve collet using some multi-purpose grease and a small screwdriver.
      Fig 1: Identifying Valve Spring And Valve Spring Retainer Special Tools
      G06094972Courtesy of FORD MOTOR CO.
  2. Disconnect the compressed air supply.
  3. Repeat the appropriate removal and installation steps for all of the other cylinders.
  4. Install the spark plugs. For additional information, refer to ENGINE IGNITION - 2.5L .
  5. Coat the valve tappets with clean engine oil and insert them.
  6. Install the camshafts. For additional information, refer to CAMSHAFTS .
scientia non olet · About LEMON Manuals