- The safety belt warning indicator is never/always on
|
- Burned-out indicator
- Circuitry
- Instrument Cluster (IC) module
- Restraints Control Module (RCM)
|
|
- The safety belt warning chime does not operate correctly
|
- Safety belt switch
- IC
module
- RCM
- Wiring, terminals or connectors
|
|
- The safety belt retractor webbing does not extract or exhibits excessive pressure on the occupant during use
|
- Safety belt retractor is in Automatic Locking Retractor (ALR) mode
- Safety belt retractor is binding internally
|
- CARRY OUT the Functional Test - Safety Belt Retractor and Functional Test - Safety Belt Retractor, Automatic Locking Retractor (ALR) Mode. REFER to COMPONENT TEST . INSTALL new components as directed.
|
- The safety belt retractor webbing does not retract or has excessive slack during use
|
- Twisted or incorrectly routed safety belt webbing
- Safety belt retractor is binding internally
|
|
| - |
|
|
- The Belt-Minder® feature does not operate correctly
|
- Belt-Minder® feature is deactivated
|
|
- Safety belt procedure after a collision
|
- Safety belt retractors
- Safety belt buckles
- Safety belt shoulder height adjuster(s)
- Center seat safety belt and buckle (lap belt, if equipped)
- Child safety seat attachment components
|
|
- The safety belt tongue is rotated on the safety belt webbing
|
- Twisted or incorrectly routed safety belt webbing
|
|
- The safety belt webbing is twisted at the safety belt guide
|
- Twisted or incorrectly routed safety belt webbing
|
|
- The safety belt webbing is dirty or soiled
|
- Dirty or soiled safety belt webbing
|
|