LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2401 (Exterior Trim & Ornamentation) >> Removal And Installation >> Rocker Panel Molding >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rocker panel pin-type retainer.
  2. Pull downward on the rocker panel lower clip flanges to release them from the body.
  3. Pull outward on the rocker panel molding to release the rocker panel upper clips from the body.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals