LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2400 (Interior Trim And Ornamentation) >> Removal And Installation >> Scuff Plate Trim Panel - Front, Lighted Outer >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The front lighter outer scuff plate is only available on the MKZ.
  1. Remove the front door scuff plate. For additional information, refer to Removal and Installation .
  2. Remove the B-pillar lower trim panel. For additional information, refer to Removal and Installation .
  3. Disconnect the scuff plate trim panel electrical connector located behind the lower B-pillar trim panel.
  4. Remove the front, lighted outer scuff plate trim panel by lifting straight up and releasing the 2 retaining clips from the body.
    NOTE: To avoid damage to the scuff plate trim panel, remove any retaining clips from the body and attach them to the scuff plate trim panel before installing.
  5. To install, reverse the removal procedure.
    • Align the retaining clips to the body and snap in place.
scientia non olet · About LEMON Manuals