Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Fusion, Milan

Remove the access cover and the screw.
Using an appropriate non-marring trim tool, pry the rear of the switch bezel upward and then shift the switch assembly rearward to disengage the front locking tab.

Fig 1: Prying Rear Of Switch Bezel Upward
Courtesy of FORD MOTOR CO.

MKZ
Using an appropriate non-marring trim tool, pry the rear of the switch bezel upward to disengage the retaining clip, then shift the switch assembly rearward to disengage the front locking tab.
NOTE: For LH front window control switch assembly only, the rear retaining clip is located off-center towards the outside of the vehicle.

All Vehicles
Disconnect the electrical connector(s).
Remove the window control switch.
To install, reverse the removal procedure.