LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2391 (Windows And Glass - Glass, Frames And Mechanisms) >> General Procedures >> Window Motor Initialization >> Initialization Procedure

Initialization Procedure

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Keep objects and body parts clear of the glass panel when carrying out the initialization procedure. During the initialization procedure, the glass panel closes with high force and cannot detect objects in its path. Failure to follow this instruction may result in serious personal injury.
NOTE: The front window must be in the full OPEN position for this procedure to operate correctly.
NOTE: If the initialization procedure is only partially completed, the front window motor will remain de-initialized and will not operate in one-touch up mode.
  1. Turn the ignition key ON.
  2. Press and hold the window control switch until the window glass stalls for 2 seconds into the glass top run and release the switch.
  3. Pull and hold the window control switch until the window glass stalls for 2 seconds at the bottom of its travel and release the switch.
  4. Test for correct window operation by carrying out the one-touch up feature. If the window does not operate correctly, carefully repeat this procedure.
scientia non olet · About LEMON Manuals