LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2387 (Clutch Controls) >> Removal And Installation >> Clutch Pedal >> Removal

Clutch Pedal: Removal

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the battery and the battery tray. For additional information, refer to BATTERY AND BATTERY TRAY -- EXPLODED VIEW .
  2. Remove the PCM.
    1. Disconnect the electrical connectors.
    2. Remove the 2 PCM bolts.
    Fig 1: Identifying PCM Connector With Bolt
    G06275845Courtesy of FORD MOTOR CO.
  3. Remove the 3 PCM bracket nuts and the bracket.
    Fig 2: Locating PCM Bracket
    G06275846Courtesy of FORD MOTOR CO.
  4. Remove the clutch master cylinder nut.
    Fig 3: Locating Clutch Master Cylinder Nut
    G06275847Courtesy of FORD MOTOR CO.
  5. Working under the instrument panel, disconnect the clutch switch (cruise control cancel) electrical connector.
  6. Disconnect the Clutch Pedal Position (CPP) electrical connector.
  7. Remove the clutch master cylinder nut and the clutch pedal bracket nut.
    Fig 4: Locating Clutch Pedal Bracket Nut
    G06275848Courtesy of FORD MOTOR CO.
  8. Remove the clutch pedal and bracket assembly.
scientia non olet · About LEMON Manuals