Clutch Pedal: Installation

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Install the clutch pedal and bracket assembly
NOTE: Make sure to align the push rod into the clutch master cylinder piston as the pedal assembly is installed.
- Apply a small amount of grease to the:
  - clevis bushing.
  - end of the clutch switch.
  - end of the master cylinder push rod.
Working under the instrument panel, connect the clutch switch (cruise control cancel) electrical connector.
Install the clutch master cylinder nut and the clutch pedal bracket nut.
- Tighten to 21 Nm (15 lb-ft).
Fig 1: Locating Clutch Pedal Bracket Nut
Courtesy of FORD MOTOR CO.
Connect the CPP electrical connector.
Install the clutch master cylinder nut.
- Tighten to 21 Nm (15 lb-ft).
Fig 2: Locating Clutch Master Cylinder Nut
Courtesy of FORD MOTOR CO.
Install the PCM bracket and the 3 PCM bracket nuts.
- Tighten to 10 Nm (89 lb-in).
Fig 3: Locating PCM Bracket With Nuts
Courtesy of FORD MOTOR CO.
Install the PCM.
1. Install the 2 PCM bolts.
  - Tighten to 10 Nm (89 lb-in).
2. Connect the electrical connectors.
Fig 4: Identifying PCM Electrical Connector
Courtesy of FORD MOTOR CO.
Install the battery tray and the battery. For additional information, refer to BATTERY AND BATTERY TRAY -- EXPLODED VIEW .