LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2385 (Bumper System) >> Removal And Installation >> Bumper - Front >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front bumper cover. For additional information, refer to BUMPER COVER - FRONT .
  2. Remove the front bumper isolator from the front bumper.
    • Pull the isolator rearward while releasing the retainers.
  3. Remove the 8 front bumper bolts (4 each side).
    • To install, tighten to 25 Nm (18 lb-ft).
  4. Remove the front bumper.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals