LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2381 (Evaporative Emissions System (Except Hybrid)) >> General Procedures >> Evaporative Emission System Leak Test >> Phase 1 - Leak Verification

Phase 1 - Leak Verification

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles 

  1. Run the EVAP  Test with the scan tool.
  2. If the Evaporative Emission (EVAP) system failed the EVAP  Test, then proceed to Phase 2.
    NOTE: Some small leaks may not be detected using the EVAP  Test. If the system has passed the test but a leak is still suspected, then proceed to Phase 2.
scientia non olet · About LEMON Manuals